M1 Monitor Service Instructions

M1: Monitor Wire Assembly Replacement

  • May 22, 2017 // Modified 7 years ago
  1. Position the handle forward to the front Forward Riser pulley
  2. Carefully remove the Top Deck by removing the Top Deck bolts and upper Tie Rods. Gently lift the Top Deck up being careful not to dislodge any of the guide pulleys. Unclip the sensor connector from the wire assembly.
  3. Remove the footboard handle rests, and loosen the rail and footboard JCN & JCB nuts and bolts so the footboard can swing away from the tank unit.
  4. Using the 5mm Allen key, remove the left key bracket. The left side being as you are sitting on the seat of the WaterRower. Also, the left key bracket is the bracket that does not house the S4 monitor. Set the key bracket and bolts aside.
  5. Using a small Phillips screwdriver, remove the S4 Monitor batteries and battery cover.
  6. Using a small Phillips screwdriver, remove the 4 small screws and S4 Monitor board from the backplate housing.
  7. Un-plug the S4 Monitor wire assembly from the back of the monitor board, pull the faulty wire assembly through the spigot tube and discard the faulty wire assembly .
  8. Feed the replacement wire assembly through the spigot tube and clip into the S4 Monitor board. The smaller white connector end of the wire assembly fits into the S4 Monitor board.
  9. Reposition the S4 Monitor board to the backplate by screwing in the 4 small screws.
  10. Replace the batteries and battery cover
  11. Replace the left key bracket.
  12. Reposition the footboard and reattach handle rests, keep handle rests loose.
  13. Plug wire assembly connector into the sensor connector and replace the top deck. Replace the upper Tie Rods and Top Deck bolts.
  14. Tighten the handle rest bolts.
  15. Reposition the handle into the handle rests and the WaterRower is ready for use.

Related Articles

  • M1: Monitor Settings Calories Burned

    m1 monitor calories burned

  • M1: Monitor Housing Replacement

    Step 1.  Remove the tie rods and JCB bolts connecting the top deck to the tank assembly as shown. Step 2– Remove the top deck assemble as shown, being careful not...

  • M1: Top Deck Replacement

    For Video Instructions, click here: Removing the Top Deck   Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown....

  • M1: Seat Guide Wheel Replacement

    1. Undo the bungee. 2. Use your 5mm ratchet (or Allen key) to remove the fastners from the rear end pad (or wooden spacer on wood models). 3.  Slide the seat...