M1 Service Instructions

M1: Level Gauge Location

The Level Gauge sticker on all Series 4 (S4) model WaterRower units, is located on the side of the tank under the tank stopper.

The Level Gauge sticker on the A1 and Indo-Row units is located on the bottom of the tank. On the A1 and GX WaterRower units, this sticker also has the unit’s serial number printed on it. To locate your serial number, see the following page: Serial Number Locations

Advised volume for WaterRower tank:

15.223 L = 15.223 kg = 33.561 Lb = 4.021 gallons

Gives you:
“Calibration level” on A1/Indo-Row sticker and ≈ “level 17.5″ on S4 sticker

The approximate height is 14 inches off the ground when upright and 8.5 inches off the ground when placed on the ground in rowing position.

Related Articles

  • M1: Monitor Sensor Disk Alignment

    If your S4 monitor is flashing zeros and not counting down, there is one simple check you can do that may solve the problem. You can check the position of...

  • M1: Monitor Board Replacement

    Step 1- Remove screws (2) fastening the battery cover at the rear of the monitor as shown. Step 2– Remove the Battery Cover as shown. Step 3- Remove the Battery...

  • M1: Tank Cover Removal

    Video Instructions: Removing & Replacing the M1 Tank Cover Step 1.  Place handle into the most forward position near the Forward Riser Pulley. Step 2.  Remove the rest bolts. Step...

  • M1: Top Deck Replacement

    For Video Instructions, click here: Removing the Top Deck   Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown....