You will need a 5mm allen wrench and a 13mm wrench.
Step 1. Remove old strap.
Step 2. Use the 5mm allen key and 13mm wrench to remove clamp and nuts. You will need to the 13mm wrench to hold the nut while unscrewing bolt with allen key.
Step 3. Replace with new nuts, bolts and clamp.
Step 4. Loop strap around back and through the slots at side, making sure length is even.
If your S4 monitor is flashing zeros and not counting down, there is one simple check you can do that may solve the problem. You can check the position of...
The Level Gauge sticker on all Series 4 (S4) model WaterRower units, is located on the side of the tank under the tank stopper. The Level Gauge sticker on the...
For Video Instructions, click here: S4 Monitor Sensor Replacement Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown. ...
1. Undo the bungee. 2. Use your 5mm ratchet (or Allen key) to remove the fastners from the rear end pad (or wooden spacer on wood models). 3. Slide the seat...