M1 Service Instructions

M1: Extrusion Replacement

  • May 22, 2017 // Modified 7 years ago

Step 1.  With the 5mm Allen key, unscrew the seat stops. There are two on the front and back of each rail.

Step 2.  Peel the old extrusion off the rail.

Step 3.  Using alcohol, remove ALL the left over adhesive. Please do not use any other solvent as it may damage the paint.

Step 4.  Once the rail surface is cleaned, attach the new extrusions. Peel away the one side of tape. Line up the seat stop holes in the extrusions to the holes in the rail. Press evenly down the length of the extrusion to adhere it firmly and smoothly to the surface of the rail.

Step 5.  With the 5mm Allen key, screw back in the rail seat stops.

Step 6.  If necessary, repeat steps 1-5 on the other rail.

Related Articles

  • M1: Recoil Belt Replacement (Clip on Recoil)

    For Video Instructions, click here: Replacing the Recoil Belt Step 1- Remove the handle from the handle rests and place the handle in the full forward position Step 2- Stand...

  • M1: Level Gauge Location

    The Level Gauge sticker on all Series 4 (S4) model WaterRower units, is located on the side of the tank under the tank stopper. The Level Gauge sticker on the...

  • M1: Monitor Sensor Replacement

    For Video Instructions, click here: S4 Monitor Sensor Replacement Step 1- Remove the handle from the handle rests and place the handle in the full forward position as shown.  ...

  • M1: Seat Guide Wheel Replacement

    1. Undo the bungee. 2. Use your 5mm ratchet (or Allen key) to remove the fastners from the rear end pad (or wooden spacer on wood models). 3.  Slide the seat...